NEC V302X User Manual

Also see for V302H: Installation guide

Contents

NEC V302X User Manual Manual pdf 36 page image

29 ... EnglishInstallationPowering On/Off the ProjectorTurn on the projectorfirst and then the signalsources.(*)When “Normal” isselected for “StandbyMode”, the Power LEDindicator will turnred; when “Networkstandby” is selected for“Standby Mode”, thePower LED indicatorwill turn orange.POWER/STANDBY1 When you firstturn on the projec-tor, you will get theStartup menu. Thismenu gives you theopportunity to selectthe menu languages.To select the language,use the , ,, or button on theremote control. Selectyour language. Pleasesee the page 53. While the POWERindicator is blinkinggreen in short cycles,the power cannot beturned off by using thepower button.Powering On the Projector1. Securely connect the power cord and signal cable. Whenconnected, the POWER/STANDBY LED will turn Red orOrange (*).2. Turn on the projector by pressing “POWER” on the remotecontrol or on the control panel. At this moment, thePOWER/STANDBY LED will now turn Green. The startup screen will display in approximately 10 seconds.The first time you use the projector, you will be asked toselect the preferred language and power saving mode.3. Turn on your source (computer, notebook, video player, etc.)The projector will detect your source automatically. If you connect multiple sources at the same time, press the“SOURCE” button on the control panel or direct source keyson the remote control to switch between inputs.