NEC UM351W User Manual

Also see for UM301W: User manual Quick setup guide Quick setup guide Quick setup guide

Contents

NEC UM351W User Manual Manual pdf 106 page image

955. Using On-Screen MenuTurning On the Projector By Applying Computer Signal [AUTO POWER ON]When the projector is in Standby mode, applying a computer or HDMI signal from a computer connected to the COM-PUTER IN input, HDMI1/MHL, or HDMI2 input will power on the projector and simultaneously project the image.This functionality eliminates the need to always use the POWER button on the remote control or the projector cabinetto power on the projector.To use this function, first connect a computer to the projector and the projector to an active AC input.NOTE:• Disconnecting a computer signal from the computer will not power off the projector. We recommend using this function in com-bination of the AUTO POWER OFF function.• This function will not be available under the following conditions:- when a component signal is applied to the COMPUTER IN terminal- when a Sync on Green RGB signal or composite sync signal is applied- when MHL signal is spplied to HDMI1/MHL IN terminal• To enable the AUTO POWER ON after turning off the projector, wait 5 seconds and input a computer or HDMI signal.If a computer or HDMI signal is still present when the projector is turned off, the AUTO POWER ON will not work and the projectorremains in standby mode.Enabling Power Management [AUTO POWER OFF]The projector has power management functions. To reduce power consumption, the power management functions (1and 2) are factory preset as shown below. To control the projector from an external device via a LAN or serial cableconnection, use the on-screen menu to change the settings for 1 and 2.1. STANDBY MODE (Factory preset: NORMAL)To control the projector from an external device, select [NETWORK STANDBY] for [STANDBY MODE].NOTE:• When [NORMAL] is selected for [STANDBY MODE], the following terminals and functions will not work:MONITOR OUT terminal, AUDIO OUT terminal, USB(PC) port, LAN functions, Mail Alert function, DDC/CI (Virtual Remote Tool)2. AUTO POWER OFF (Factory preset: 1 hour)To control the projector from an external device, select [OFF] for [AUTO POWER OFF].NOTE:• When [1:00] is selected for [AUTO POWER OFF], you can enable the projector to automatically turn off in 60 minutes if there isno signal received by any input or if no operation is performed.Selecting Default Source [DEFAULT SOURCE SELECT]You can set the projector to default to any one of its inputs each time the projector is turned on.LAST �� Sets the projector to default to the previous or last active input each time the projector is turned on�AUTO �� Searches for an active source in order of COMPUTER → HDMI1/MHL → HDMI2 → VIDEO → USB-A →USB-B → COMPUTER and displays the first found source�COMPUTER �� Displays the computer signal from the COMPUTER IN terminal every time the projector is turned on�HDMI1/MHL �� Displays the digital source from the HDMI 1/MHL IN terminal every time the projector is turned on�HDMI2 �� Displays the digital source from the HDMI 2 IN terminal every time the projector is turned on�VIDEO �� Displays the Video source from the VIDEO IN terminal every time the projector is turned on�USB-A �� Displays slides or plays back movie files from the USB memory device every time the projector is turnedon�LAN�� Displays a signal from LAN port (RJ-45) or the USB Wireless LAN Unit�USB-B �� Displays the computer signal from the USB (PC) terminal every time the projector is turned on�