252. Projecting an Image (Basic Operation) After UsePreparation: Make sure that the projector is turned off.1. Unplug the power cord.2. Disconnect any other cables.• Remove the USB memory if it is inserted into the projector.3. Retract adjustable tilt foot if extended.4. Slide the lens cover to the right to cover the lens.5. Put the projector and accessories in the supplied soft case.Place the projector in the soft case with the lens facing upward as shown below. This is to prevent the lens fromdamage.NOTE: When placing the projector in the soft case, retract the tilt foot and the rear feet. Failure to do so may case damage to theprojector.CAUTION:Use caution when putting the projector in the soft case immediately after the projector has been operating. Theprojector cabinet is hot.Insert the projector with the lensfacing upward
