935. Using On-Screen MenuSetting up the Projector for a Wired LAN Connection [WIRED LAN]Important• Consult with your network administrator about these settings.• When using a wired LAN connection, connect a LAN cable (Ethernet cable) to the LAN port (RJ-45) of the projec-tor. (→ page 110)TIP: The network settings you make will not be affected even when [RESET] is done from the menu.[WIRED LAN] [DISABLE] Wired LAN connection will be turned off.[ENABLE] Wired LAN connection will be turned on.[SETTINGS] [DHCP] ON�������������������������� IP address, subnet mask, and gateway willbe automatically assigned to the projectorfrom your DHCP server�OFF������������������������� Specify IP address, subnet mask, and gate-way assigned by your network administra-tor�[IP ADDRESS] Set your IP address of the network connected to theprojector.[SUBNET MASK] Set your subnet mask number of the network connectedto the projector.[GATEWAY] Set the default gateway of the network connected to theprojector.[AUTO DNS] ON�������������������������� DHCP server will automatically assign IPaddress of DNS server connected to theprojector�OFF������������������������� Set your IP address of DNS server connectedto the projector�
