1126. Installation and ConnectionsPrepare a Phillips screw driver beforehand.1. Press the POWER button to turn off the projector and set itinto standby condition, and disconnect the power cord.2. Remove the USB (LAN) port cover.Loosen the screw securing the port cover.• The screw is not removable.3. Slowly insert the USB Wireless LAN Unit into the USB (LAN)port.Remove the cap from the USB Wireless LAN Unit, and then insertit with the surface (side of indicator) facing outward. Keep the capfor later use.NOTE: Do not force to insert the USB Wireless LAN Unit.4. Put the USB (LAN) port cover back into place.Insert the catch of the USB (LAN) port cover into the groove of theprojector cabinet, and then tighten the screw to secure the portcover.To remove the USB Wireless LAN Unit, disconnect the power cordand use the above procedure.NOTE:• The green LED on the USB Wireless LAN Unit flashes to show that WirelessLAN Unit is working. If the USB Wireless LAN Unit is incorrectly attached,the blue LED will not flash.• Do not press the button on the USB Wireless LAN Unit. The button will notwork with this model.WIRELESSWIRELESSWIRELESSWIRELESS
