Installing Windows Server 2003 E-7Windows Server 2003 Clean InstallationThis section explains how to perform a clean installation of Windows Server 2003.1. Turn on the system power.2. Insert the Windows Server 2003 CD-ROM into the DVD-ROM drive.3. Press Ctrl + Alt + Delete to reset the system.After a bootable operating system has been installed on the hard disk, press Enter whilethe message "Press any key to boot from CD..." is displayed at the top of the screen.If no bootable operating system exists on the hard disk, this step is unnecessary.The Windows Server 2003 setup screen will appear.If the screen is not displayed, Enter was not pressed properly.Begin after turning on the system power again.4. If the RAID controller or SCSI controller is installed in the system, press F6 in a fewseconds when the window is in either of the following states.– "Setup is inspecting your computer's hardware configuration ..." is displayed.– A screen with a solid blue background is displayed.IMPORTANT: There is no visible indication on screen when F6 hasbeen pressed.5. When the following message is displayed, press S.Setup could not determine the type of one or more mass storage devicesinstalled in your system, or you have chosen to manually specify an adapter.Currently, Setup will load support for the following mass storage devices.The following message is displayed.Please insert the disk labeledmanufacturer-supplied hardware support diskinto Drive A:*Press ENTER when ready.6. Insert the Windows Server 2003 OEM-DISK for NEC EXPRESSBUILDER into thefloppy disk drive, and press Enter.A list of mass storage devices is displayed.7. Select the [LSI Logic Fusion-MPT SAS Driver (Server 2003 32-bit)] and press Enter.
