|
4-16 Windows SetupStep 4: Start the ft series SetupFollow the steps below to perform ft series setup:IMPORTANT: If you skip the settings of Step 3 “Disable Boot Monitoring Function”(page 4-11), BIOS will be restarted forcefully while Windows setup screen is shown andthe setup will be unsuccessful; BIOS may repeat Windows setup in an invalid manner. Insuch case, you will need to restart the setup procedures from the beginning.1. Turn on the NEC Express5800/ft series.2. Insert the NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive of the server.IMPORTANT: For ft series setup, insert the CD-ROM into the PCI module forGroup1’s CD-ROM drive.3. When having inserted the CD-ROM correctly, reset the system (press Ctrl, Alt and Deletetogether), or turn the power off and then turn it on to restart the NEC Express5800/ft series.The system starts through the CD-ROM, and NEC EXPRESSBUILDER is activated.4. Click [Setup].5. When the following message appears, click [Confirm].NoteWe recommend that you should save the system information to yourcomputer after system setup. If not, you will not be able to recover theinformation. You can save the information by the following process:(1)Select 'Tools'. (2)Select 'Off-line Maintenance Utility'.(3)Select 'System Information Management'. (4)Select 'Save'.[Confirm]
|
