NEC Express 320Lc User Manual

Also see for Express 320Lc: User guide User guide User guide

Contents

NEC Express 320Lc User Manual Manual pdf 139 page image

6-20 TroubleshootingTroubleshootingThis section describes what you should do when a trouble occurs in the product.Problems with NEC EXPRESSBUILDERWhen the server is not booted from the NEC EXPRESSBUILDER CD-ROM, check the following: Did you set the NEC EXPRESSBUILDER CD-ROM during POST and restart the server?→ If you do not set the NEC EXPRESSBUILDER CD-ROM during POST and restart theserver, an error message will appear or the OS will boot. Is BIOS configuration correct?→ The boot device order may be specified with the BIOS setup utility of the server. Use theBIOS setup utility to change the boot device order to boot the system from the CD-ROMdrive first. [Boot]>When an error occurs while the NEC EXPRESSBUILDER is in progress, the following messageappears. After this message appears, check the error and take the appropriate corrective action accordingto the error codes listed in the table below.Message Cause and RemedyThis machine is not supported. This NEC EXPRESSBUILDER version isnot designed for this server. Execute theNEC EXPRESSBUILDER on the compliantserver.NvRAM access error An access to the nonvolatile memory(NvRAM) is not acceptable.Hard disk access error The hard disk is not connected or it is failed.Check whether the hard disk is correctlyconnected.An error message will also be displayed when an error was detected during system diagnosis. Take anote or print the error message displayed, and contact your sales agent.