|
Windows Setup 4-11Step 3: Disable Boot Monitoring FunctionCheck whether the power is ON and make settings for properly performing setup for later on.This equipment has a function to monitor the main unit at startup. (Enabled in the configuration atshipment)When reinstalling the operating system, this monitoring function needs to be disabled. Otherwisethe installation may not be done properly. Follow the steps in this section and make proper settings.IMPORTANT: If you skip the settings described here, the system will be restartedforcefully while Windows setup screen is shown and the setup will be unsuccessful; BIOSmay repeat Windows setup in an invalid manner. In this case, you will need to restart thesetup procedures from the beginning.TIPS: For details of operations for BIOS Setup Utility and parameters, see the separatevolume of User’s Guide.1. Turn on the display and the peripheral equipment connected to the NEC Express5800/ftseries.CHECK: If the power cords are connected to a power controller like a UPS,make sure that it is powered on.TIPS: When the AC power of the NEC Express5800/ft series is turned on, afterthe power is supplied, BMC is synchronized between the PCI modules. Upon thecompletion of the BMC synchronization, the POWER LED of either PCI modulewill be lit.2. Detach the front bezel in the case of a rack-mount model (or open it in the case of a towermodel).
|
