NAPCO LIBRA LIB-P432EX Programming Instructions Manual

Contents

NAPCO LIBRA LIB-P432EX Programming Instructions Manual Manual pdf 1 page image

HARDWIRE WIRELESSL I B R A - P 4 3 2 E X S e r i e sCONTROL PANEL/COMMUNICATORProgramming the LIBRA LIB-P432EX, LIB-P432EXT, LIB-P432EXT-230 control panels with theGEM-DXRP2, GEM-DXRP3, GEM-DXK2, GEM-DXK3 and GEM-DXK4RF Series KeypadsWI1771 9/08© NAPCO 2008Quick Start (for GEM-DXK2):1. Refer to the wiring diagram, connect Siren, Aux. Power, PGM Out-put, Remote Bus, Earth Ground, Zone and Telephone Wiring. NOTE:See Installation Instructions (WI1691).2. Connect AC power first and then the battery.3. Configure the keypad (see page 55).4. Access the Easy Menu Driven (Dealer Program) Mode:Press456789 wPress NO ("X" or q) until "TURNON PROG Y/N" appears on the keypad.Press YES ("r" or p) to enter Dealer Program Mode. See page 5.Quick Start (for GEM-DXK3):1. Refer to the wiring diagram, connect Siren, Aux. Power, PGM Out-put, Remote Bus, Earth Ground, Zone and Telephone Wiring. NOTE:See Installation Instructions (WI1691).2. Connect AC power first and then the battery.3. Configure the keypad (see page 55).4. Access the Easy Menu Driven (Dealer Program) Mode:Press456789 wPress NO ("X" or q) until "17" appears on the keypad.Press YES ("r" or p) to enter Dealer Program Mode. See page 5.PROGRAMMINGINSTRUCTIONSRPublicly traded on NASDAQ Symbol: NSSCGEM-DXK2Dealer Code Dealer CodeGEM-DXK332DXK4RF-319 KeypadDXK4RF-433 Keypad™