Manitowoc S0850M Installation Use And Care Manual

Also see for S0850M: Service manual

Manitowoc S0850M Installation Use And Care Manual Manual pdf 33 page image

Section 4 MaintenancePart Number 80-1560-3 4-11Water Inlet ValveThe water inlet valve normally does not require removalfor cleaning. Refer to Section 5 for a list of causes for“No Water Entering Water Trough” or “Water OverflowsWater Trough.1. When the ice machine is off, the water inlet valvemust completely stop water flow into the machine.2. When the ice machine is on, the water inlet valvemust allow the proper water flow through it. Set thetoggle switch to ON. Watch for water flow into the icemachine. If the water flow is slow or only trickles intothe ice machine, refer to Section 5.Follow the procedure below to remove the water inletvalve.1. Remove the 1/4” hex head screws.2. Remove, clean, and install the filter screen.Removing the Front Panel1. Disconnect power to ice machine.2. Loosen thumbscrews. Do not remove they areretained by o-rings to prevent loss..Panel Removal! WarningDisconnect the electric power to the ice machineand dispenser at the electric service switch box andturn off the water supply before proceeding.SV1622FILTERACCESSSCREWSWATERINLETVALVEThumbScrews