Maintenance Section 44-4 Part Number 80-1560-3SANITIZING PROCEDUREUse sanitizer to remove algae or slime. Do not use it toremove lime scale or other mineral deposits.Step 1 Set the toggle switch to the OFF position afterice falls from the evaporator at the end of a Harvestcycle. Or, set the switch to the OFF position and allowthe ice to melt off the evaporator.Step 2 Remove all ice from the bin.Step 3 Refer to Removal of Parts For Cleaning/Sanitizing and remove ice machine parts.Step 4 Mix a solution of water and sanitizer.Step 5 Use the sanitizing solution and a sponge orcloth to sanitize (wipe) all parts and interior surfaces ofthe ice machine. Sanitize the following areas:A. Side wallsB. Base (area above water trough)C. Evaporator plastic partsD. Bin or dispenserStep 6 Rinse all sanitized areas with clear water.Step 7 Install the removed parts, restore power andplace toggle switch in the ice position.Step 8 T o start a sanitizing cycle, move the toggleswitch to the CLEAN position. The water will flowthrough the water dump valve and down the drain. TheClean light will turn on to indicate the ice machine is inthe sanitizing mode.Step 9 Wait about two minutes or untill water starts toflow over the evaporator.Step 10 Add the proper amount of Manitowoc IceMachine Sanitizer to the water trough by pouringbetween the water curtain and evaporator.Step 11 The ice machine will automatically time out aten minute sanitizing cycle, followed by six rinse cycles,and stop. The Clean light will turn off to indicate thesanitizing cycle is completed. This entire cycle lastsapproximately 30 minutes.Step 12 When the sanitizing process stops, move thetoggle switch to ICE position.! CautionNever use anything to force ice from the evaporator.Damage may result.! WarningDisconnect electric power to the ice machine (anddispenser if applicable) at the electric switch boxbefore proceeding.Solution Type Water Mixed WithSanitizer 4 gal. (15 l) 3 oz (90 ml) sanitizerModel Amount of SanitizerS0850M 5 ounces (148 ml)