Troubleshooting Section 55-8 Part No. 80-1214-3QF2200/QF2300The evaporator and motor / gearbox are separateassemblies. Warranty procedures require replacementof the entire evaporator or motor /gearbox assembly.Separate components are not available, and fieldrebuilding during the warranty period is not allowed.1. Disconnect power and water supply to the icemachine and drain all water from the reservoir andevaporator.2. Remove reservoir retaining pin, water reservoir, icechute, and drain tubing (refer to ComponentRemoval).3. Remove bolts securing foundation coupling to base.4. Lift and support evaporator (evaporator weighs 80lbs.).5. Remove gear motor drip shield and disconnect linevoltage wiring at motor Molex connector.6. Remove two screws holding motor speed sensorand remove sensor.7. Remove bolts securing gear motor assembly tobase.8. Remove gear motor assembly from ice machine.9. Remove coupling (use a 8 mm hex wrench forcoupling set screw), spline hub and keyway fromgear motor.10. Apply anti-seize compound to the shaft and all boltsto ease future disassembly.3SV3017768Revised 8/2003