Makita SW400MP Original Instruction Manual

Also see for BR400MP: Original instruction manual Original instruction manual

11 ENGLISHOverall inspection• Tighten loose bolts, nuts and screws.• Check for damaged parts, brushes, or sweepdrums. Ask our authorized service center toreplace them if necessary.Inspecting the brushes, sweepdrums, and protectorCheck and clean the brushes, sweep drums, and pro-tector daily. If they are worn, bent and cracked, replacethem.Replacing the brushes or sweepdrums1. Remove the clips from the brushes or sweepdrums, and then remove the brushes or sweep drums.12► 1. Brush 2. Clip2. Attach the brushes or sweep drums to the brushunit or sweep drum unit, and then attach the clips.NOTICE: When attaching the brushes, besure to attach them with the Makita logo facingoutside.NOTICE: When attaching the sweep drums, besure to attach them in the direction shown in thefigure, so that the sweep drums and the gear casemesh with each other.1 2► 1. Sweep drum 2. Gear caseLubricating moving partsNOTICE: Follow the instruction of the fre-quency and amount of grease supplied. Otherwiseinsufficient lubrication may damage moving parts.Gear case:CAUTION: Do not apply grease when thegear case is hot. Hot gear case can cause burninjury.Fill approx. 30 ml of grease (Makita grease SG No.0)through the grease port evenly every 25 hours ofoperation.With the supplied hexalobular wrench, remove the boltnear the lubrication marking on the gear case. Loosenthe bolt on the other side so that the air in the gear casecan be released when applying the grease.After applying the grease, be sure to tighten the bolts.