Lenovo ThinkSystem SR650 Series Setup Manual

Also see for ThinkSystem SR650: Manual Manual Quick start guide Maintenance manual Product guide

Contents

Server model: eight 2.5-inch SAS/SATA drives, eight 2.5-inch SAS/SATA/NVMe drives, the rear hot-swap drive assembly, three 8i RAID adapters, one NVMe switch adapterNotes:• The cable routing illustration is based on the scenario that the rear hot-swap drive assembly is installed.Depending on the model, the rear hot-swap drive assembly and the 8i RAID adapter in PCIe slot 6 mightnot be available on your server.• Depending on the model, if the NVMe switch adapter is installed in PCIe slot 1, route the NVMe signalcable along the right side of the chassis.Figure 40. Cable routing for server models with eight 2.5-inch SAS/SATA drives, eight 2.5-inch SAS/SATA/NVMe drives,the rear hot-swap drive assembly, three 8i RAID adapters, and one NVMe switch adapterCable From To1 Power cable for front backplane 1 Power connector on front backplane1Backplane power connector 1 on thesystem board2 SAS signal cable for frontbackplane 1SAS 0 and SAS 1 connectors on frontbackplane 1C0 and C1 connectors on the 8i RAIDadapter installed on the RAID adapterslot3 NVMe signal cable for frontbackplane 1NVMe 0, NVMe 1, NVMe 2, andNVMe 3 connectors on frontbackplane 1NVMe 0–1 and NVMe 2–3 connectorson the system board4 NVMe signal cable for frontbackplane 2NVMe 0, NVMe 1, NVMe 2, andNVMe 3 connectors on frontbackplane 2C0, C1, C2, and C3 connectors onthe NVMe switch adapter installed inPCIe slot 5Chapter 2. Server components 67