Table 1. Server specifications (continued)Specification DescriptionGraphics processing unit(GPU)Your server supports the following GPUs or processing adapters:• Full-height, full-length, double-slot GPUs or processing adapters: AMD MI25,AMD V340, NVIDIA® M10, NVIDIA M60, NVIDIA P40, NVIDIA P100, NVIDIA P6000,NVIDIA RTX5000, NVIDIA V100, and NVIDIA V100S• Full-height, full-length, single-slot GPU: NVIDIA P4000, NVIDIA RTX4000, andCambricon MLU100-C3• Full-height, half-length, single-slot GPU: NVIDIA V100• Low-profile, half-length, single-slot GPUs: NVIDIA P4, NVIDIA P600, and NVIDIAP620, NVIDIA T4, and Cambricon MLU270-S4Note: The NVIDIA V100 GPU has two types of form factor: full-height full-length(FHFL) and full-height half-length (FHHL). Hereinafter the full-height full-length V100GPU is called as the FHFL V100 GPU; the full-height half-length V100 GPU is calledas the FHHL V100 GPU.GPU installation rules:• For Intel Xeon SP Gen 2 ith the supported system board, you can install up to fiveNVIDIA P4 or NVIDIA T4 GPUs in PCIe slots 1, 5, 6, 2 and 3.• For Cambricon MLU100-C3 processing adapters, you can only install twoadapters in slots 5 and 6, or install four adapters in slots 1, 2, 5 and 6.• Before installing a GPU, ensure that the air baffle in your server is appropriate forthe GPU. For more information about the air baffle, refer to “Important informationabout the air baffle and GPU” on page 14.• To install a full-height GPU, or the NVIDIA P4 GPU, you need to use the GPUthermal kit. For more information, see “Install a GPU with the GPU thermal kit” onpage 165.• For NVIDIA P600, NVIDIA P620, NVIDIA P4000, NVIDIA RTX4000, and FHHL V100GPUs, you can install up to three GPUs in PCIe slots 1, 5, and 6. For the othersupported GPUs, you can install up to two GPUs in PCIe slots 1 and 5.Notes:– If NVIDIA P4 is installed in PCIe slot 1, PCIe slot 5, or both slots, keep PCIe slot2, PCIe slot 6, or both slots unoccupied.– For server models installed with three NVIDIA P4 can be installed in PCIe slot 1,PCIe slot 5, and PCIe slot 6 at the same time, the operating temperature mustbe equal to or less than 35°C.– If up to five NVIDIA P4 GPUs are installed, the server models support no morethan eight 2.5-inch hot-swap SAS/SATA/NVMe drives and the operatingtemperature must be equal to or less than 35°C.– For server models installed with FHHL V100 GPU, NVIDIA T4 or CambriconMLU270-S4 GPU, the operating temperature must be equal to or less than30°C.– If one NVIDIA T4 or Cambricon MLU270-S4 GPU is installed, install in slot 1.– For server models installed with one CPU, if two NVIDIA T4 or CambriconMLU270-S4 GPUs are installed, install in slot 1 and slot 2. For server modelsinstalled with two CPUs, if two NVIDIA T4 or Cambricon MLU270-S4 GPUs areinstalled, install in slot 1 and slot 5.– For server models installed with one CPU, if three NVIDIA T4 or CambriconMLU270-S4 GPUs are installed, install in slot 1, slot 2 and slot 3. For servermodels installed with two CPUs, if three NVIDIA T4 or Cambricon MLU270-S4GPUs are installed, install in slot 1, slot 5 and slot 6.– Four NVIDIA T4 or Cambricon MLU270-S4 GPUs are supported only for servermodels installed with two CPUs, and installed in slot 1, slot 2, slot 5, and slot 6.Chapter 1. Introduction 9