Lenovo ThinkSystem SR650 Series Setup Manual

Also see for ThinkSystem SR650: Manual Manual Quick start guide Maintenance manual Product guide

Contents

Figure 77. System fan cage removalStep 1. Rotate the levers of the system fan cage to the rear of the server.Step 2. Lift the system fan cage straight up and out of the chassis.After removing the system fan cage, begin installing any options that you have purchased.Install a processor-heat-sink moduleThis task has instructions for installing an assembled processor and heat sink, known as a processor-heat-sink module (PHM), a processor, and a heat sink. All of these tasks require a Torx T30 driver.Note: If you are installing multiple options relating to the system board, the PHM installation should beperformed first.“Read theinstallationGuidelines” onpage 126“Power offthe server forthis task” onpage 194“ATTENTION:Static Sensitive DeviceGround package before opening”on page 127Attention:• Intel Xeon SP Gen 2 is supported on the system board with part number 01PE847. If you use the systemboard with part number 01GV275, 01PE247, or 01PE934, update your system firmware to the latest levelbefore installing a Intel Xeon SP Gen 2. Otherwise, the system cannot be powered on.• Each processor socket must always contain a cover or a PHM. When removing or installing a PHM,protect empty processor sockets with a cover.• Do not touch the processor socket or processor contacts. Processor-socket contacts are very fragile andeasily damaged. Contaminants on the processor contacts, such as oil from your skin, can causeconnection failures.• Remove and install only one PHM at a time. If the system board supports multiple processors, install thePHMs starting with the first processor socket.134 ThinkSystem SR650 Setup Guide