3. After you haveLenovo XClarity Essentials OneCLI in place, type the following command to set theDMI:onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag [access_method]Where:The server asset tag number. Type asset aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa, whereaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa is the asset tag number.[access_method]The access method that you select to use from the following methods:– Online authenticated LAN access, type the command:[−−imm xcc_user_id:xcc_password@xcc_internal_ip]or[−−bmc xcc_user_id:xcc_password@xcc_internal_ip]Where:xcc_internal_ipThe BMC/IMM/XCC internal LAN/USB IP address. The default value is 169.254.95.118.xcc_user_idThe BMC/IMM/XCC account name (1 of 12 accounts). The default value is USERID.xcc_passwordThe BMC/IMM/XCC account password (1 of 12 accounts). The default value isPASSW0RD (with a zero 0 not an O).Notes:a. BMC, IMM, or XCC internal LAN/USB IP address, account name, and password are allvalid for this command.b. If you do not specify any of these parameters, OneCLI will use the default values. When thedefault values are used and OneCLI is unable to access the Lenovo XClarity Controllerusing the online authenticated LAN access method, OneCLI will automatically use theunauthenticated KCS access method.Example that does use the user ID and password default values:onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag – Online KCS access (unauthenticated and user restricted): You do not need to specify a valuefor access_method when you use this access method.Note: The KCS access method uses the IPMI/KCS interface, which requires that the IPMIdriver be installed.Example that does not use the user ID and password default values:onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag – Remote LAN access, type the command:Note: When using the remote LAN/WAN access method to access Lenovo XClarity Controllerfrom a client, the host and the xcc_external_ip address are required parameters.[−−imm xcc_user_id:xcc_password@xcc_external_ip]or100 ThinkSystem SR550 Setup Guide |
