Lenovo ThinkSystem SR250 Quick Start Manual

Also see for ThinkSystem SR250: Messages and Codes Reference Setup guide Manual Product guide

ThinkSystem SR250Type 7Y51 and 7Y52Quick Start PN: SP47A37086Printed in ChinaYour shipping box contains the following items: SR250 Material box, including printed documentationIf any item is missing or damaged, contact your place of purchase.Ensure that you retain your proof of purchase and packing material.They might be required to receive warranty service.First glanceServer front view: Four drives modelVGA connector (optional) Front operator panelUSB 2.0 connector Four drive bays (0-3)USB 3.1 Gen 1 connector Rack release latches Ten 2.5-inch hot-swap drives modelUSB 2.0 connector VGA connector (optional)USB 3.1 Gen 1 connector Ten 2.5-inch hot-swap drivebays (0-9)Front operator panel Rack release latchesServer rear view: Fixed power supply modelPCIe slot 1Ethernet connector 1(shared with XCC networkport)PCIe slot 2Dedicated XClarityController (XCC) networkconnectorPower connector VGA connectorUSB 3.1 Gen 2 connectors Serial connectorEthernet connector 2Note 1: For the rear view of the redundant power supply model, thereare two power connectors on your server.Note 2: Depending on the configuration, the illustrations above mightdiffer slightly from your server.Setting up the System1. Install the required solution components.2. Install the enclosure into the rack.See the Rack Installation Guide that was provided with the rail kit.3. Connect the cables.4. Connect the management controller to the network.5. Power on the nodes.6. Configure the system.For detailed information about installing hardware options andconfiguring the system, see the following website:http://thinksystem.lenovofiles.com/help/topic/7Y51/introduction.html

/ 2

Related manuals for Lenovo ThinkSystem SR250