Lenovo ThinkSystem SD530 Quick Start Manual

Also see for 7X20: Manual

Lenovo ThinkSystem SD530 Compute Node Type 7X21Lenovo ThinkSystem D2 Enclosure Type 7X20,Modular Enclosure Type 7X22Quick StartPN: SP47A24250Printed in ChinaIn the boxYour shipping box contains the following items: SD530 Compute Node Type 7X21 D2 Enclosure Type 7X20 or Modular Enclosure Type 7X22Note: There will be one to four nodes per enclosure in the boxdepending on your purchase. Material box, including items such as power cords, printeddocumentation and slide-rail installation kit.If any item is missing or damaged, contact your place of purchase.Ensure that you retain your proof of purchase and packing material.They might be required to receive warranty service.First glanceNote: Your solution might look slightly different from the illustrations.Enclosure front view: Node baysNode front view: Six 2.5-inch hot-swap drive modelNode front view: Four 2.5-inch hot-swap drive modelEnclosure rear view: Eight low-profile PCIe 3.0 x8 cardsEnclosure rear view: Four low-profile PCIe 3.0 x16 cardsSystem Management Module (SMM)ThinkSystemsingle Ethernet port SMMThinkSystemdual Ethernet port SMMInstalling the solutionTo install the solution, do the following:1. Install the required solution components.2. Install the enclosure into the rack.See the Rack Installation Guide that was provided with the rail kit.3. Connect the cables.4. Turn on the compute nodes.5. Connect the management controller to the network.6. Configure the system.For detailed information about installing hardware options andconfiguring the system, see the following website:http://thinksystem.lenovofiles.com/help/topic/7X21/introduction.html

/ 2

Related manuals for Lenovo 7X20