8200 Series Converged Network Adapter and 3200 Series Intelligent Ethernet Adapter Page 75Linux Diagnostic Test Descriptions• Internal Loopback Test performs internal packet loopback.• Flash Test verifies the Flash read and write.• Hardware Test verifies that the hardware is running.• Interrupt Test enables and disables the interrupt and functional verification tests.• Link Test verifies that the port is linked, meaning that the port has a good cable attached to the portand that other end of the cable is connected to an operational Ethernet port, either another NIC port ora network device, such as a switch.• Register Test verifies the NIC register read and write.Linux Diagnostic Test MessagesTest information and PASS or FAIL messages are displayed for each of the tests listed in “Linux DiagnosticTest Descriptions” on page 75.QLogic Device Windows Property Page DiagnosticsThis section covers the following information for user diagnostics for Windows NIC driver managementapplications:• “Running Windows User Diagnostics” on page 75• “Windows Diagnostic Test Descriptions” on page 79• “Windows Diagnostic Test Messages” on page 80Running Windows User DiagnosticsYou can run user diagnostics using either the QConvergeConsole GUI or the CLI.To run user diagnostics in the GUI:1. Access the Windows Control Panel, and then open the Device Manager.2. In the Device Manager, right-click the QLogic 10Gb Ethernet adapter, and then on the shortcut menu,click Properties.Note: Information on installing and starting the GUI version of QLogic's QConvergeConsole utility isprovided in the QConvergeConsole User's Guide. All procedural information for that utility iscovered in the QConvergeConsole Help System.
