8200 Series Converged Network Adapter and 3200 Series Intelligent Ethernet Adapter Page 17Chapter 2. Configuring NICThis chapter describes the driver and QConvergeConsole (QCC) agent installation, configuration,operation, and troubleshooting of the NIC function of the 8200 and 3200 Series Adapters. For informationabout QCC Agents, refer to the QCC User’s Guide.Installing NIC in LinuxFor information about packaging content, Linux OS support, supported features, driver installation, driverremoval, and driver system parameters, refer to the Ethernet Networking Driver Readme file (IntelligentEthernet Adapter and Converged Network Adapter Inbox Driver Update on the QLogic Web sitehttp://driverdownloads.qlogic.com.Installing NIC in ESX/ESXiFor information about packaging content, ESX OS support, driver installation, and driver removal, refer tothe Networking Driver Readme file (Intelligent Ethernet Adapter and Converged Network AdapterNetworking Driver for ESX/ESXi) on the QLogic Web site http://driverdownloads.qlogic.com.Installing NIC in WindowsFor information about packing content, Windows OS support, driver installation, and driver removal, referto the Ethernet Networking Driver Readme file (Intelligent Ethernet Adapter and Converged NetworkAdapter NDIS Miniport Driver for Windows) on the QLogic Web site http://driverdownloads.qlogic.com.Configuring PXE BootThis section provides procedures for configuring the 8200 and 3200 Series Adapters to perform PXE boot.The example uses function 1 and NIC 1.To configure PXE boot:1. Enter the system BIOS by pressing the F2 key.2. On the BIOS window (Figure 3), select Integrated Devices, and then press the ENTER key.Figure 3: Dell BIOS: Integrated Devices
