8200 Series Converged Network Adapter and 3200 Series Intelligent Ethernet Adapter Page 30Creating a TeamTo create a team:1. To create a team, right-click the Teams folder icon, and then click Create Team (Figure 8).Figure 8: Creating a Team2. The software automatically picks a unique team name, or you can enter your own team name. Teamnames must be unique on a system.3. On the Create Team dialog box, specify the following (see the message pane at the bottom of thedialog box for more details), and then click OK to return to the adapter properties:— Name—Type a name for the new team.— Type—Select the teaming mode by clicking either Failsafe Team, 802.3ad Static Team, 802.3adDynamic Team, or Switch Independent Load Balancing. If you select the 802.3ad dynamicoption, you must also select one of the following options:• Active LACP: LACP is a Layer 2 protocol that controls the teaming of physical ports into anaggregated set. LACP discovers if a host’s ports are connected to a switch that supportsaggregation on the connected ports and configures those ports into an aggregation bundle. ForLACP to operate, one side has to be Active LACP. The Active LACP side of the protocol initiatesthe protocol.• Passive LACP: The Passive LACP side responds to the active LACP requests.— Adapters to Add—Select the check box next to each adapter that should form the team.
