Menu
Lenovo 8200 Series Installation Manual
                                                                                                                                    | |
Contents
|
8200 Series Converged Network Adapter and 3200 Series Intelligent Ethernet Adapter Page 863. On the Adapter Type Configuration Selection menu, select 1, CNA Configuration.4. On the Converged Network Adapter (CNA) Protocol Type Selection menu, select 1, CNA iSCSIConfiguration.5. On the Converged Network Adapter (CNA) iSCSI Configuration menu, select 3, Port IP Settings.6. Select the Converged Network Port you want to configure.7. Select 2, Configure IP Settings.8. Complete the interactive list of settings as follows:a. Enable IPv4 [on]: Press the ENTER key to accept the default.b. DHCP to obtain IPv4 Network Information: [off]: Press the ENTER key to accept thedefault.c. IP_Address []: Type the IP address of the initiator system, and then press the ENTER key.d. IP_Subnet_Mask [255.255.255.0]: Type the appropriate subnet mask, and then press theENTER key.e. IP_Gateway [0.0.0.0]: Press the ENTER key to accept the default.f. Enable IPv6 [off]: Press the ENTER key to accept the default.9. On the options menu that opens, select 3, Save changes and reset HBA (if necessary).10. At the prompt for both ports, type Yes.11. To return to the Converged Network Adapter (CNA) iSCSI Configuration menu, type p and press theENTER key, and then type p and press the ENTER key again.12. On the Converged Network Adapter (CNA) iSCSI Configuration menu, select 4, Target Configuration.13. Select the same Converged Network Port you selected in step 6 on page 86.14. Select 6, Add a Target.15. Complete the interactive list of settings as follows:a. IPv6 Target? [off]: Press the ENTER key to accept the default.b. TGT_iSCSI_Name []: Type the iSCSI qualified name (IQN) of the iSCSI target to connect to, andthen press the ENTER key.c. TGT_Port [3260]: Press the ENTER key to accept the default.d. TGT_TargetIPAddress [0.0.0.0]: Type the IP address of the target, and then press theENTER key.16. On the options menu that opens, select 12, Save Target/CHAP Changes.The iSCSI initiator is now configured to connect to the iSCSI target.Configuring an iSCSI Initiator in WindowsUse QConvergeConsole CLI to configure the iSCSI initiator for Windows.To configure a Windows iSCSI initiator:1. Access the QConvergeConsole CLI either by double-clicking the QCC CLI desktop icon or by enteringqaucli in the CMD window.2. On the QConvergeConsole CLI Main Menu, select 2, Adapter Configuration.3. On the Adapter Type Configuration Selection menu, select 1, CNA Configuration.4. On the Converged Network Adapter (CNA) Protocol Type Selection menu, select 1, CNA iSCSIConfiguration.5. On the Converged Network Adapter (CNA) iSCSI Configuration menu, select 3, Port IP Settings. |
Related manuals for Lenovo 3200 Series
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved