Diagnostic Error Code FRU/Action025-02X-XXX 025-03X-XXX 025-04X-XXX IDE Interfacefailure1. IDE signal cable2. Check power supply3. Reseat IDE signal cable4. IDE device5. System board025-195-XXX IDE interface Test aborted by user Information only Re-start the test, if necessary025-196-XXX IDE interface test halt, error thresholdexceeded1. Press F3 to review the log file2. Re-start the test to reset the log file025-197-XXX IDE interface test warning 1. Make sure the component that is called out isconnected and/or enabled. See Chapter 6 “Usingthe Setup Utility” on page 392. Re-run test3. Replace the component that is called out in warningstatement4. Replace the component under test025-198-XXX IDE interface test aborted 1. If a component is called out, make sure it isconnected and/or enabled. See Chapter 6 “Usingthe Setup Utility” on page 392. Flash the system and re-test. See “Flash updateprocedures” on page 2593. Go to “Undetermined problems” on page 73025-199-XXX IDE interface test failed, cause unknown 1. Go to “Undetermined problems” on page 732. Flash the system and re-test. See “Flash updateprocedures” on page 2593. Replace component under function test030-000-XXX SCSI interface Test Passed No action030-00X-XXX 030-01X-XXX SCSI interface failure 1. SCSI signal cable2. Check power supply3. SCSI device4. SCSI adapter card, if installed5. System board030-027-XXX SCSI interface Configuration/Setup error 1. SCSI signal cable2. Flash the system. See “Flash update procedures” onpage 2593. SCSI device4. SCSI adapter card, if installed5. System board030-03X-XXX 030-04X-XXX SCSI interface error 1. SCSI signal cable2. Check power supply3. SCSI device4. SCSI adapter card, if installed5. System board030-195-XXX SCSI interface Test aborted by user Information only Re-start the test, if necessary62 ThinkStation Hardware Maintenance Manual