![Lenovo 410554U Hardware Maintenance Manual Manual pdf 62 page image](https://manuals-archive2.s3.amazonaws.com/5270738/f13512f6c3f75dd127e2874326094da162f.jpg)
Diagnostic Error Code FRU/Action005-016-XXX Video Simple Pattern test failure 1. Video Ram2. Video card, if installed3. System board005-024-XXX Video Addressing test failure 1. Video card, if installed2. System board005-025-XXX Video Checksum Value error 1. Video card, if installed2. System board005-027-XXX Video Configuration/Setup error 1. Run Setup2. Video drivers update3. Video card, if installed4. System board005-031-XXX Video Device Cable failure 1. Video cable2. Monitor3. Video card, if installed4. System board005-032-XXX Video Device Controller failure 1. Video card, if installed2. System board005-036-XXX Video Register error 1. Video card, if installed2. System board005-038-XXX System BIOS extension failure 1. Video card, if installed2. System board005-040-XXX Video IRQ failure 1. Video card, if installed2. System board005-195-XXX Video Test aborted by user Information only Re-start the test, if necessary005-196-XXX Video test halt, error threshold exceeded 1. Press F3 to review the log file2. Re-start the test to reset the log file005-197-XXX Video test warning 1. Make sure the component that is called out isconnected and/or enabled. See Chapter 6 “Usingthe Setup Utility” on page 392. Re-run test3. Replace the component called out in warningstatement4. Replace the component under test005-198-XXX Video test aborted 1. If a component is called out, make sure it isconnected and/or enabled. See Chapter 6 “Usingthe Setup Utility” on page 392. Flash the system and re-test. See “Flash updateprocedures” on page 2593. Go to “Undetermined problems” on page 73005-199-XXX Video test failed, cause unknown 1. Go to “Undetermined problems” on page 732. Flash the system and re-test. See “Flash updateprocedures” on page 2593. Replace component under function test56 ThinkStation Hardware Maintenance Manual