Diagnostic Error Code FRU/Action018-250-XXX PCI Card Services error 1. PCI card2. Riser card, if installed3. System board020-000-XXX PCI Interface Test Passed No action020-0XX-XXX PCI Interface error 1. PCI card2. Riser card, if installed3. System board020-195-XXX PCI Test aborted by user Information only Re-start the test, if necessary020-196-XXX PCI test halt, error threshold exceeded 1. Press F3 to review the log file2. Re-start the test to reset the log file020-197-XXX PCI test warning 1. Make sure the component that is called out isconnected and/or enabled. See Chapter 6 “Usingthe Setup Utility” on page 392. Re-run test3. Replace the component that is called out in warningstatement4. Replace the component under test020-198-XXX PCI test aborted 1. If a component is called out, make sure it isconnected and/or enabled. See Chapter 6 “Usingthe Setup Utility” on page 392. Flash the system and re-test. See “Flash updateprocedures” on page 2593. Go to “Undetermined problems” on page 73020-199-XXX PCI test failed, cause unknown 1. Go to “Undetermined problems” on page 732. Flash the system and re-test. See “Flash updateprocedures” on page 2593. Replace component under function test020-262-XXXPCI system error 1. PCI card2. Riser card, if installed3. System board025-000-XXXIDE interface Test Passed No action025-00X-XXX 025-01X-XXX IDE interface failure 1. IDE signal cable2. Check power supply voltages3. Reseat IDE signal cable4. IDE device5. System board025-027-XXX IDE interface Configuration/Setup error 1. IDE signal cable2. Flash the system. See “Flash update procedures” onpage 2593. Reseat IDE signal cable4. IDE device5. System boardChapter 9. Symptom-to-FRU Index 61
