6: Basic ParametersSLC™ 8000 Advanced Console Manager User Guide 79Load Cellular Gateway Firmware Options3. To save your entries, click the Apply button. Apply makes the changes immediately andsaves them so they will be there when the SLC 8000 advanced console manager is rebooted.Ethernet CountersThe Network > Network Settings (1 of 2) page displays statistics for each of the SLC Ethernetports since boot-up. The system automatically updates them.Note: For Ethernet statistics for a smaller time period, use the diag perfstatcommand.Network CommandsGo to Network Commands to view CLI commands which correspond to the web page entriesdescribed above.IP FilterIP filters (also called a rule set) act as a firewall to allow or deny an individual MAC address orindividual or a range of IP addresses, ports, and protocols. When a network connection isconfigured to use an IP filter, all network traffic through that connection is compared, in order, tothe rules of that filter. Network traffic may be allowed to pass, it may be dropped (without notice),or it may be rejected (sends back an error packet) depending upon the rules of that filter rule set.The administrator uses the Network > IP Filter page to view, add, edit, delete, and map IP filters.Warning: IP filters configuration is a feature for advanced users. Adding andenabling IP filter sets incorrectly can disable access to your SLC unit.Radio FirmwareFilenameEnter the name of the radio firmware filename exactly as it is represented.Load Firmware via Select the method to load the firmware from the options in the drop-down menu.Options are: FTP, TFTP, SCP, USB, SD Card, and HTTPS. FTP is the default. If you select HTTPS, the Upload File link becomes active. Select the link to opena popup window that allows you to browse to a firmware update file to upload. If you select NFS, the mount directory must be specified.Note: Connections available depend on the model of the SLC unit.USB Port Select the USB port. The firmware files must be stored in the top level directory ofthe USB flash drive.FTP/SFTP/SCPServerEnter the IP address or host name of the server used for obtaining the firmwarefiles. May have up to 64 alphanumeric characters; may include hyphens andunderscore characters.Path Enter the path on the server for obtaining firmware update files.Login Enter the user login for the FTP/SFTP/SCP server to verify access. May be blank.Password/Retype PasswordEnter the FTP/SFTP/SCP user password. Retype the password in the RetypePassword field.
