9: Device PortsSLC™ 8000 Advanced Console Manager User Guide 182Apply settings to Device Ports and enter port numbers separated by commas. Indicate arange of port numbers with a hyphen (e.g., 2, 5, 7-10), and separate ranges with commas.4. To save, click the Apply button.Logging CommandsGo to Logging Commands to view CLI commands which correspond to the web page entriesdescribed above.Console PortThe console port initially has the same defaults as the device ports. Use the Devices > ConsolePort page to change the settings, if desired.To set console port parameters:1. Click the Devices tab and select Console Port. The following page displays:Figure 9-12 Devices > Console Port2. Change the following as desired:Baud The speed with which the device port exchanges data with the attached serialdevice.From the drop-down list, select the baud rate. Most devices use 9600 for theadministration port, so the console port defaults to this value.Data Bits Number of data bits used to transmit a character. From the drop-down list, selectthe number of data bits. The default is 8 data bits.Stop Bits The number of stop bits that indicate that a byte of data has been transmitted.From the drop-down list, select the number of stop bits. The default is 1.
