User manual Page 51www.keit.co.uk Using the system and software: DOC0535 (10 July 2019, 16:56)Back to Table of Contents5.8 Configure chemometricsA. Add model buttonNew chemometric models may be added with the Add model button. Keit Spec supportsmost Camo Analytics’ Unscrambler, Eigenvector Solo or PLS Toolbox, and Univariatemodels; for more details, see Section 5.8.1 Supported model types, below. CamoAnalytics’ Unscrambler is supported by incorporating the Unscrambler X Engine version10.4.1.The Camo Analytics or Eigenvector tools are required to build models that can then beimported to the Keit software. Export the model file from your analysis software, and thenload it into the Keit software. The data stored in the current batch or project will be re-analysed against the model and the results presented in the Trends panel of the Batchviewer tab (for continuous project), or the Data panel of the Sample Acquisition tab (formanual projects). If you are using Modbus or OPC-UA to connect to a plant’s distributedcontrol system (DCS), the results of the models will be available over those interfaces for
