38 | English0 276 001 XXX | (17.1.11) Bosch ebike SystemsProduct Description andSpecificationsTechnical DataProduct Features (see page 6–7)The numbering of the product features refers tothe illustration of the battery charger on thegraphics page.12 Rear rack battery13 Battery charge control indicator18 Standard battery21 Battery charger22 Ventilation openings23 Charger socket24 Mains voltage selector switch25 Charger plug26 Safety warnings, charger27 Button for charge operation28 Operation indicator29 Charge connector30 Socket for charge connectorOperationf Place the battery only on clean surfaces. Inparticular, avoid contaminating the chargesocket and the contacts, e.g. by means ofsand or ground.Initial OperationConnecting the Charger (see figures E–F)Set the voltage of your power source on themains voltage selector switch 24 of the charger.You can select between 115 V and 230 V.f Observe the mains voltage! The voltage ofthe power supply must correspond with thedata given on the nameplate of the batterycharger. Battery chargers marked with 230 Vcan also be operated with 220 V.Then, insert the charger plug 25 of the powercord into the charger socket 23 of the charger.Connect the mains cable to the mains supply.The operation indicator 28 on the charger lightsup.f Do not connect the charger to the mainssupply until after the correct mains voltagehas been set on the mains voltage selectorswitch 24. Otherwise, the charger can be-come damaged.Switch the battery off and remove it from theholder of the eBike. For this, read and observethe operating instructions of the battery.Insert the charge connector 29 of the batterycharger into the socket 30 on the battery. Theoperation indicator 28 on the charger flashes.Battery Charger ChargerArticle number 0 275 007 900Rated voltage V 115/230Frequency Hz 50/60Battery chargingvoltage V= 36Charging current– Rapid-chargingoperation– Silent-chargingoperationAA41Allowable chargingtemperature range °C 0...+40Charge duration (for8 Ah battery capacity)approx.– Rapid-chargingoperation– Silent-chargingoperationhh2.58Number of batterycells 10–80Weight according toEPTA-Procedure01/2003 kg 0.8Protection class /IThe values given are valid for a nominal voltage [U] of230 V. For different voltages and models for specificcountries, these values can vary.
