Kärcher 550.0 Operator's Manual

Kärcher 550.0 Operator's Manual Manual pdf 7 page image

9.800-079.0 • Rev. 05/147PRESSURE WASHER OPERATOR’S MANUALASSEMBLY INSTRUCTIONSSTEP 1: Attach the highpressure hose to the spraygun using teflon tape on hosethreads.STEP 3: Release the coupler collarand push the nozzle until the collarclicks. Pull the nozzle to make sure itis seated properly.STEP 5: Connect the high pressurehose to the pump discharge fitting. Pushcoupler collar forward until secure.STEP 2: Pull the spring-loaded collarof the wand coupler back to insert yourchoice of pressure nozzle.STEP 6: Connect garden hose to thecold water source.STEP 7: Connect the garden hoseto pump water inlet. Inspect inlets.CAUTION: Do not run the pumpwithout water or pump damagewill result.SafetyLatchSprayGunHigh PressureHoseWandCouplerSoapNozzlePressureNozzleWandCouplerWandCollarDischarge FittingHigh Pressure HoseColdWaterSourceGardenHosePumpWater InletGardenHoseCoupler CollarDipStickSTEP 4: Remove shipping capand install oil dipstick. Checkpump oil level by using dipstickor observe oil level in oil win-dow (if equipped). Use 30 wt.non detergent oil.Oil Window