9.800-079.0 • Rev. 05/14OPERATOR’S MANUAL PRESSURE WASHER6COMPONENT IDENTIFICATIONPressureSwitchBrassSoapNozzleNozzleQuickCouplerSprayGunHigh PressureHoseDetergentInjectorQuickCouplerCollarDischargeNippleWater SupplyHose(not included)GasolineTankWand CouplerVariable PressureControl wandControl WandHandleTriggerSwivelConnectorUnloaderBattery BoxPump — Develops high pressure.Starter Grip — (Not Shown) Used for starting theengine manually.Spray Gun — Controls the application of water anddetergent onto cleaning surface with trigger device.Includes safety latch.Detergent Injector — Allows you to siphon and mixdetergents.Variable Pressure Control Wand — Must be con-nected to the spray gun. This wand handle controlsdishcharge flow from one tube to both wand tubes.When water is discharged from both tubes you will havea pressure loss and allows chemical siphoning whenused in combination with a detergent injector.High Pressure Hose — Connect one end to waterpump discharge nipple and the other end to spraygun.Note: If trigger on spray gun is released for morethan 2 minutes, water will leak from valve. Warmwater will discharge from pump protector onto floor.This system prevents internal pump damage.Pump