Jet JWL-1840EVS Operating Instructions And Parts Manual

Also see for JWL-1840EVS: Operating instructions and parts manual Operating instructions and parts manual Operating instructions Operating instructions

Jet JWL-1840EVS Operating Instructions And Parts Manual Manual pdf 7 page image

75.0 Setup and assemblyThe Lathe must bedisconnected from power during assembly.5.1 Shipping contentsCarton contents (see Figure 5-1)1 Lathe bed with headstock, tool support andtailstock – A1 Tool rest – B2 Legs – C1 Spur center – D1 Live single bearing center – E1 Live cone center – F1 Live cone center pin – G1 Knockout rod – H1 Faceplate – J (installed on lathe)1 Tool rest extension – K1 Faceplate wrench – L4 Adjustable foot – M1 Tool shelf – N2 Riser blocks – P1 Hardware package1 Operating Instructions & Parts Manual1 Warranty CardHardware package (p/n JWL1840-HP) contents:8 Soc. hd. cap screws, 5/16x1-1/4 – HP0018 Lock washers, 5/16 – HP0028 Flat washers, 5/16 – HP0032 Soc. hd. cap screws, 3/8x3/4 – HP0046 Lock washers, 3/8 – HP0054 Hex cap screws, 3/8x1-1/4 – HP0064 Flat washers, 3/8 – HP0075.2 Tools required for assemblyHex keys, 6mm, 8mmOpen end wrench, 14mm5.3 Unpacking and cleanup1. Remove all smaller items from main carton. Donot discard carton or packing material untillathe is assembled and running satisfactorily.2. Inspect contents for shipping damage; if any isfound, report it to your distributor.3. Compare contents of shipping carton with thecontents list in this manual. Report shortages,if any, to your distributor. Note: Check lathefirst – some parts may have been pre-installed.4. Exposed metal areas of the Lathe, such asbedways and spindles, have been factorycoated with a protectant. This should beremoved with a soft cloth and a cleaner-degreaser. Clean the bed areas underheadstock, tailstock and tool support base. Donot use an abrasive pad, and do not allowsolvents to contact painted or plastic areas.Figure 5-1: shipping contents (not to scale)5.4 Installing leg set and riser blocksSee Figures 5-2 and 5-3.1. If you desire to install the riser blocks for a 4”height increase, mount them to bottom of legsusing fasteners (HP006/5/7) Tighten firmly.2. Install adjustable feet into bottom of legs orriser blocks (Figure 5-2) and tighten hex nutagainst leg casting. The feet can be adjustedlater.Figure 5-2: riser blocks and feetLathe is heavy – use cautionduring leg installment procedures. Use strapsin good condition. Straps/lifting mechanismsmust be properly rated for lathe weight.