33 To close Management Application1 Click [ (Close)]2 Select [Save changes - restart services], and click[OK].Management Application is closed.Caution:● Never turn off the power while saving settings ofManagement Application.● When you change settings of Management Application,restart the Management Application service; otherwise,the new settings are not applied.Connecting CamerasUse the [Add Hardware Devices...] wizard to registercameras in the network with the system and enable setupand operations from NVR.● User name and password for each camera are necessaryfor camera registration. Please check them in advance.For details, refer to the instruction manual of the cameras.Caution:● You need to configure an IP address for each networkcamera in advance.● By default, the IP address for LAN1 is 192.168.0.253 andthe subnet mask is 255.255.255.0.● It is necessary to set the IP address of the networkcamera in the same segment* as LAN1 of this unit. If thecamera and this unit are not on the same network, thecamera cannot be registered. Confirm that the IP addressof the camera and LAN1 are in the same segment. If theyare in different segments, consult your networkadministrator.Example: When the subnet mask is 255.255.255.0IP address of this unit: 192.168.0.253IP address of the camera: 192.168.0.100* Segment: Underlined sections● Do not set multiple devices to the same IP address.Otherwise, settings cannot be made correctly.1 Click [Add Hardware Devices...]The wizard will start.● Check to ensure that the [Express (recommended)]check box is selected.2 Click [Next]Automatic detection of cameras connected to the network starts.When the automatic detection is completed, a list ofcameras detected appears.● Depending on the network configuration, the camera maynot be detected automatically. Click [Rescan] when thereis any camera that is not shown in the list. When thecamera is still not shown, register the camera manually.(A Page 115 "Manually Registering a Camera")● VN-C215U will not be detected automatically. Pleaseregister it manually. (A Page 115 "ManuallyRegistering a Camera")● If the user name and password of a camera have beenchanged from the initial settings, there is a chance thatthe camera will not be automatically detected.
