124 ReferenceBy enabling SNMP, you can monitor the status of this unitfrom an SNMP manager on the surveillance computer. Formonitoring, you need to register MIB extension information(JVCNVRMIB.txt) with the SNMP manager.1 Insert a USB flash memory to the SERIALterminal2 Double-click [4. Unit Setup] on the desktopThe [Unit Setting] window appears.3 Click [SNMP Setting]The [SNMP Setup] window appears.4 Select the [Enable SNMP] check box in the[SNMP Setting] section● Select the [Enable TRAP] check box in the [SNMPSetting] section to use TRAP.● For TRAP notifications supported by this unit, refer to"A list of TRAPs supported by this unit" (A Page 125).5 Enter the IP address of the surveillancecomputer in the [SNMP Manager IP address]field6 Specify the SNMP community nameExample: kanshi1Caution:● You can use up to 32 characters for the community name.● For TRAP, transmission may fail at the recipient side dueto its communication specifications. Use TRAP only as anauxiliary measure and use polling judgment as a primarymeasure.7 Click [Copy extended MIB file to flash memory]● The MIB extension information (JVCNVRMIB.txt) iscopied to a USB flash memory.8 Resister the MIB extension information with theSNMP manager on the surveillance computer● For procedures to register the obtained MIB extensioninformation with the surveillance computer, refer to therelevant instruction manuals of the SNMP manager.9 Configure settings for monitoring (polling) bythe SNMP manager on the surveillancecomputer● For setup procedures, refer to the relevant instructionmanuals of the SNMP manager.● For available statuses supported by this unit, refer to "Alist of statuses that can be obtained from this unit"(A Page 125).Caution:● To disconnect the USB device from the unit, be sure toperform “remove” by right-clicking the target removal diskon the explorer.Setting SNMP
