JVC LVT1306-007A Instructions Manual

Also see for RX-F31S: Instructions Service manual Service manual

Contents

45For various playback:(one touch replay):Move the playback position back 10 secondsbefore the current position.RETURN: Return to the main menu during menuoperation.CANCEL: Cancel the programmed track, etc.Only for DVD recorder operations:CHANNEL +/–: Change the channel numbers.DVD/HDD: Select the DVD recorder or HDD deck. (Only fora DVD recorder incorporated with HDD deck.)(skip): Move the playback position ahead 30 secondsafter the current position.1 – 9, 0: Select a channel number (while stopped) or achapter/title number, track number (while playingback). Press ENTER to enter the number.REC MODE: Select the recording mode.REC PAUSE: Enter recording pause. To start recording,press 3.DISPLAY: Change the display information.Only for DVD player operations:fs/Rate*: Show the sampling frequency.TITLE/GROUP: Make the numeric buttons work for selecting thetitle/group number.ZOOM: Zoom in and out.1 – 10, 0, +10: Select a chapter/title number, track number,menu item, etc.DVD/CARD: Select the disc or memory card to play. (Only fora DVD player incorporated with memory cardslots.)DIMMER: Change the display brightness.THUMBNAIL: Show the thumbnail screen for JPEG discs.SLIDE: Start the slide show playback for JPEG discs.3D/S.EFFECT: Apply the 3D effect.PAGE: Show browsable still pictures on DVD Audiodiscs.* Press and hold when using these buttons.If these buttons do not function normally, use the remotecontrol supplied with your DVD recorder or DVD player.Refer also to the manuals supplied with the DVD recorderor DVD player for details.After setting the mode selector correctly, you can perform thefollowing operations on the DVD recorder or DVD player.See the instructions supplied with the DVD recorder or DVDplayer for details.7 Changing the remote control code for DVDrecorderSome JVC DVD recorders can accept four types of the controlsignals. You can assign one of the four codes to the remotecontrol supplied with this receiver for operating your DVDrecorder. For details, refer to the manual supplied with theDVD recorder.Initial setting: 031 Set the mode selector to “DVR.”2 Press and hold DVR/DVD .3 Press DVR/DVD.4 Enter the remote control code you want usingbuttons 1 – 4, and 0.EX.: To enter the code “2”, press 0, then 2.Code for DVR Number to enter1 012 023 034 045 Release DVR/DVD .Now, the remote control code has been changed.You can always perform the following operation:DVR/DVD : Turn on or off the DVD recorder or DVD player.3: Start playback.7: Stop playback.8: Pause playback. To release it, press 3.¢: Skip to the beginning of the next chapter.4: Return to the beginning of the current (orprevious) chapter.¡: Fast-forward playback.1: Fast-reverse playback.TOP MENU/MENU:Display the menu recorded on discs.ON SCREEN: Shows the on-screen bar.5/∞/3/2: Select an item on the menu screen.ENTER: Enter the selected item, channel number,chapter/title number, or track number (ifrequired).You can also use the following buttons to operate JVC DVDrecorder and/or DVD player if it supports the correspondingfunction:For various settings:AUDIO: Select the audio language/channel.SUBTITLE: Select the subtitle language.SET UP: Display the Preference display.VFP: Show the picture adjustment screen.PROGRESSIVE*: Change the scanning mode.ANGLE: Select the view angle.