JVC LVT1306-007A Instructions Manual

Also see for RX-F31S: Instructions Service manual Service manual

Contents

317 Making the center tone soft or sharp—CENTER TONEThis setting is available when one of the Surround/DSP modes isin use. To activate Surround/DSP mode, see page 42.• This setting is common to all Surround modes, and ismemorized separately for DSP modes.• You cannot adjust the center tone in the following cases:– When “CENTER SPEAKER” is set to “CENTER SPK: NO”(see page 21).– When Dual Mono software is played back.– While listening with the headphones.Adjustable range: 1 to 5 (in 1 step intervals)Initial setting: CENTER TONE: 3As the number increases, the dialogue becomes stronger.Normally, select “3.”• When the center tone is set to other than “CENTER TONE: 3,”the C.TONE indicator lights up on the display.From the remote control:You can also make adjustments the following way from theremote control.Set the mode selector to “AUDIO/TV/VCR/STB.”Press SOUND, then press C.TONErepeatedly.NOTEAfter pressing SOUND, the numericbuttons work for sound adjustments. Touse the numeric buttons to operate yourtarget source, press the correspondingsource selecting button before operation;otherwise, the remote control may notwork as you intend.7 Align the vertical localization of the centerchannel —CENTER ALIGNMENTThis setting is available when one of the Surround/DSP modes(except “PLII MUSIC” and “ALL CH ST”) is in use. To activateSurround/DSP mode, see page 42.• Once you have made an adjustment, it is memorized for eachSurround/DSP mode.• You cannot adjust the center alignment in the following cases:– When “CENTER SPEAKER” is set to “CENTER SPK: NO”(see page 21).– When Dual Mono software is played back.– While listening with the headphones.C ALIGNMENT: ON Select when you cannot feel as if the actorsor singers are speaking or singing on thescreen.C ALIGNMENT: OFF Select not to use this function.Initial setting: C ALIGNMENT: OFFAdjusting the sound parameters for theSurround/DSP modesYou can adjust the Surround/DSP sound parameters to yourpreference.• For details about the Surround/DSP modes, see pages 38 to 43.7 Adjusting the effect level for DSP modes—EFFECTThis setting is available only when one of the DSP modes (exceptALL CH ST) is in use. To activate DSP mode, see page 42.• Once you have made an adjustment, it is memorized for eachDSP mode.Adjustable range: 1 to 5 (in 1 step intervals)Initial setting: EFFECT: 3As the number increases, the effect becomes stronger.Normally, select “3.”From the remote control:You can also make adjustments the following way from theremote control.Set the mode selector to “AUDIO/TV/VCR/STB.”Press SOUND, then press EFFECTrepeatedly.NOTEAfter pressing SOUND, the numericbuttons work for sound adjustments. Touse the numeric buttons to operate yourtarget source, press the correspondingsource selecting button before operation;otherwise, the remote control may notwork as you intend.7 Adjusting the panorama control for Pro Logic IIMusic—PANORAMAThis setting is available only when Pro Logic II Music is in use. Toactivate Pro Logic II Music, see page 42.• Once you have made an adjustment, it is memorized until youchange the setting.PANORAMA: ON Select to add “wraparound” sound effect withside-wall image.PANORAMA: OFF Select to listen to originally recorded sound.Initial setting: PANORAMA: OFF