JVC LVT1306-007A Instructions Manual

Also see for RX-F31S: Instructions Service manual Service manual

Contents

14Adjusting the subwoofer audiopositionIf the subwoofer sound is much reinforced for stereo soundcompared to the sound reproduced with multi-channel, set thesubwoofer audio position. The subwoofer output level isautomatically decreased by the selected value when you arelistening in stereo.The AUDIO P. indicator lights up when this function is activated.• Once you have made an adjustment, it is memorized for eachsource.From the remote control ONLY:Press SOUND, then press A.POSITION repeatedly.• Each time you press A.POSITION, the subwoofer audio positionlevel changes as follows:AUDIO P. indicatorThe smaller the number becomes, the more the level decreasesautomatically when listening in stereo.• If no adjustment is required, select “OFF” (initial setting).NOTES• The minimum subwoofer output level is –10 dB.Ex.: When setting the subwoofer output level to “–8 (dB)” andthe subwoofer audio position to “–4 (dB),” the subwooferoutput level when listening in stereo will be –10 dB.To adjust the subwoofer output level, see page 29.• This function is not available when the Surround/DSP mode isactivated or “DVD MULTI” is selected.• After pressing SOUND, the numeric buttons work for soundadjustments. To use the numeric buttons to operate your targetsource, press the corresponding source selecting button beforeoperation; otherwise, the remote control may not work as youintend.Activating TV DirectTV Direct enables you to use this receiver as an AV selectorwhile the receiver is turned off.When TV Direct is activated, the pictures and sounds go from thevideo components such as DVD player to the TV through thisreceiver. Thus, you can use the video components and the TV asif they were connected directly.• This function takes effect for the following sources—DVR/DVD,VCR, and VIDEO.To activate (or deactivate) TV Direct, follow the procedure below:1 Press TV DIRECT.All the indications disappear, then the source lamp of thecurrent source lights in green.2 Turn on the video component and TV.3 Select the target video component.On the front panel:Turn SOURCE SELECTOR until one of thesource lamps—DVR/DVD, VCR, or VIDEO—lights in green.From the remote control:Press one of the source selecting buttons—DVR/DVD, VCR, or VIDEO.The source lamp corresponding to the selected source lightsin green.To cancel TV Direct and turn off the receiver, pressSTANDBY/ON on the front panel (or AUDIO on the remotecontrol).The receiver is turned off and the standby lamp lights up.To cancel TV Direct and turn on the receiver, press TV DIRECTagain.The receiver is turned on and the source lamp currently selectedlights in red.NOTES• When TV Direct is activated, you cannot enjoy any of the soundeffects the receiver produces, and cannot use the speakersconnected to the receiver.• You can use the T-V LINK function between the TV and VCRwhile TV Direct is activated. (For T-V LINK functions, refer to themanuals supplied with the TV and the VCR.)• When TV Direct is activated while “DVD MULTI,” “FM,” or “AM” isselected as the source, the source changes to the last selectedsource—“DVR/DVD,” “VCR,” or “VIDEO.”When operating the receiverusing the remote control, setthe mode selector to“AUDIO/TV/VCR/STB.”EQLPCM LLS SB RSS . WFRPLNEO : 6DSP 3DLFEC RDOLBY DDTS AAC96 / 24 AUTO SRC.TONE VIRTUAL SB AUDIO P. BASS TA NEWS INFO RDS TUNED ST SLEEPAUTO MUTING AUTO MODEATTHPMHzkHz–2 –4 –6OFF (canceled)