JVC LST0728-001C Instructions Manual

Contents

97Input/Output Terminal on Rear Panel● The audio input acts as a network device in the VR-N1600U/Esystem, and the device name assigned to it is ANVRB. The input/output terminals on the rear panel have been assigned to theANVRB device by default. (VR-N1600U/E)● In VR-N900U, analog input circuitry is considered as a networkencoder (IP video server), and the device name assigned to it isAN900B. The input/output terminals on the rear panel have beenassigned to the AN900B device by default. (VR-N900U) Rear Panel Input Terminals Output TerminalsNote :● Although the duration of output for the rear panel outputterminals is indicated as0 seconds, it is infinitely output.● Output events of the rear output terminals cannot be deleted.● All terminal inputs are treated as alerts, but there can only beassociation (sequence) between one terminal with recordingstart.Specifying a VMD Event1 Select the camera for specifying the VMD eventfrom the [Defined events] list on the [I/O Setup]screen2 Click the [Add VMD Event(Motion Detection)]buttonIf a multi-camera device is selected, such as a network encoder (IPvideo server), a dialog for you to select the required camera willappear.Note :● The [Add VMD Event(Motion Detection)] button is disabled ifthere is no VMD event available for the network camera.Specifying Timer EventsYou can add a timer event to an added event.A timer event is defined with respect to an input event and istriggered by that event. Timer events are triggered when thespecified time interval has lapsed after occurrence of the inputevent at the preset destination.1 Select the event for adding a timer event fromthe [Defined events] list on the [I/O Setup]screen(An example of adding a timer event to the inputevent)2 Click the [Add new event...] button● The [New Timer] screen appears.3 Specify the timer interval and timer event name.Rear Panel InputTerminal NameName of Input Event Event DescriptionALARM IN 1 to 8(VR-N1600U/E)ALARM IN 1 to 4(VR-N900U)Alarm IN 1 to 8 Falling(VR-N1600U/E)Alarm IN 1 to 4 Falling(VR-N900U)Event duringdetection of Makesignal inputAlarm IN 1 to 8 Rising(VR-N1600U/E)Alarm IN 1 to 4 Rising(VR-N900U)Even duringdetection of Breaksignal inputRear Panel OutputTerminal NameName of Output Event Output ActionOPTION OUT1,2Set output Option Out 1,2highOutputs the MakestatusSet output Option Out 1,2lowOutputs theBreak statusItem DescriptionA Timerevent isstartedby:Displays the event or event button name forwhich a timer event is added. (This is a read-only field.)B TimereventnameFor specifying a name for the timer event.C Timereventoccursafter:For specifying the time interval from theoccurrence of the event or clicking of the eventbutton until the timer event is triggered. Specifythe time interval in seconds or minutes.[I/O Setup] ScreenABC[New Timer] Screen