SW-2000M-CL-65217.1 Group A: General settings7.1.1 MODE – select camera operating modeThe command MODE selects the operating mode that will be entered when the camera isrebooted.Command DescriptionMODE ? Returns the MODE setting syntax and a list of available modesto select from.MODE Returns the present setting of MODE.MODE Sets a new operating mode. Reboot required.7.1.2 NET - network settingsThe Ethernet control interface settings can be changed using the NET group of commands.Caution: Setting incorrect network properties can cause the camera to be unreachablethrough the network. If this happens, please use the Camera Link interface to reset thenetwork settings.Command DescriptionNET ? Returns the NET settings syntax for manual/DHCP, IP address,Gateway and Subnet Mask.NET Returns the present setting of manual/DHCP, IP Address,Subnet Mask and Gateway together with the settings after thenext reboot of the camera.7.1.2.1 NET IP - set the IP addressThe command NET IP sets the IP address of the camera. Default is 10.10.10.10.Command DescriptionNET IP ? Returns the NET IP setting syntax.NET IP Please use command NET for settings information.NET IP Sets the camera to use a static IP address xxx.xxx.xxx.xxx.NET IP AUTO Sets the camera to obtain a dynamic IP address using DHCP.Caution: It is recommended to use a static IP address. If a dynamic address is selected,there is no straightforward way to determine the address assigned by the DHCP server. Theaddress must be queried through the Camera Link serial interface.
