SW-2000M-CL-65227.1.2.2 NET MASK – set the IP subnet maskThis command sets the IP subnet mask of the camera. The command has no effect in case ofusing dynamic IP addressing.Command DescriptionNET MASK ? Returns the syntax for setting NET MASK.NET MASK Please use command NET for settings information.NET MASK Sets the camera to use an IP subnet mask.7.1.2.3 NET GATEWAY – set the IP default gatewayThe command NET GATEWAY sets the IP default gateway (default router) of the camera. Thecommand has no effect in case of using dynamic IP addressing.Command DescriptionNET GATEWAY ? Returns the NET GATEWAY syntax.NET GATEWAY Please use command NET for settings information.NET GATEWAY Sets the address of the default gateway.7.1.2.4 NET FACTORY RESET – resetting the net settingsThe command NET FACTORY RESET sets the net to the factory default values.Command DescriptionNET FACTORY RESET Resets the network settings to factory default values.7.1.2.5 NET NAME – set a name for the camera for the networkCommand DescriptionNET NAME ? Returns the NET NAME syntax.NET NAME Please use command NET for settings information.NET NAME Sets the name of the camera.NET NAME DELETE Removes the name.7.1.2.6 NET CLOSE – close the current sessionThis command closes the current session immediately.Command DescriptionNET CLOSE Ends the current Telnet session.Alternative commands are NET QUIT and BYE.
