10 Applicable to US/CA market10.1 Supplier's Declaration ofConformityIssuer: Husqvarna AB, Drottninggatan 2, S-56182 Huskvarna, Swedenwww.husqvarnagroup.com.Responsible party: Husqvarna ProfessionalProducts, Inc. 9335 Harris Corners ParkwaySuite 500 Charlotte, NC 28269 United StatesU.S. Contact information: James McNew,Manager Product Compliance, Telephone: +1704 597 5000.10.2 Compliance requirementsFCC ID: XPY1CGM5NNN (Automower® Connectmodule).FCC ID: ZASHQ-BLE-1A and FCC ID ZASHQ-BLE-1B (Bluetooth® module).The Bluetooth module is located on the HMI-board (PCBA) in the upper chassis. It must onlybe accessed by an authorized service technician.The device complies with part 15 of the FCCRules. Operation is subjected to the following 2conditions:1. This device may not cause harmfulinterference.2. This device must accept any interferencereceived, including interference that maycause undesired operation.WARNING: To comply with RFexposure requirements, pleasemaintain a separation distance of atleast 20 cm/ 7 inches from any part ofthe product.Models with a hatch: The supplied label shall beattached to the product according to figure below.Husqvarna Automower® ConnectThis device contains the moduleFCC ID: XPY1CGM5NNNModels without a hatch: The supplied label shallbe attached to the product according to figurebelowHusqvarna Automower® ConnectThis device contains the moduleFCC ID: XPY1CGM5NNNNote: Changes or modifications made to thisequipment not expressly approved by Husqvarnamay void the FCC authorization to operate thisequipment.Note: This device complies with Part 15 of theFCC Rules [and with Industry Canada licence-exempt RSS standard(s)]. Operation is subject tothe following two conditions: this device may notcause harmful interference, and this device mustaccept any interference received, includinginterference that may cause undesired operation.1201 - 001 - 05.06.2019 Applicable to US/CA market -59