Husqvarna AUTOMOWER 430X Operator's Manual

Also see for AUTOMOWER 420: Operator's manual Operator's manual Operator's manual Operator's manual Operator's manual

If the product charges in theSecondary areamode, it will fully charge, move out about 50 cm /20 in. and then stop. This means that the productis charged and prepared to start to cut.Note: It is recommended to change the operationselection toMain area before you put the productin the charging station.4.3.4 Spot cuttingSpot cutting means that the product mows in aspiral pattern in order to cut the grass in the areawhere it was started. You can select how theproduct must continue to operate when cutting iscomplete.• Use the right arrow button to selectMainArea orSecondary Area.4.4 Operating mode - ParkWhen selectingPark the following operationselections can be selected:• Park until further notice• Start again in 3 hours• Start with next timer4.4.1 Park until further noticeThe product stays in the charging station untilanother operating mode is selected by pressingthe START button.4.4.2 Start again in 3 hoursThe product stays in the charging station for 3hours and then automatically goes back to theusual operation. This operation selection isapplicable when it is necessary to pauseoperation.4.4.3 Start with next timerThe product stays in the charging station andstarts to operate on the nextTimer setting.4.5 To stop the product1. Press the STOP button on top of theproduct.The product stops and the blade motor stops.4.6 To switch off the product1. Press the STOP button on top of theproduct.2. Set the Main switch to position0.WARNING: Always switch off theproduct using the main switch if itrequires maintenance, or if the productmust be moved outside the work area.4.7 To charge the batteryWhen the product is new or has been stored for along period, the battery can be empty and needsto be charged before starting. In theMain areamode, the product automatically alternatesbetween mowing and charging.WARNING: Only charge the productusing a charging station and a powersupply which is intended for it.Incorrect use may result in electricshock, overheating or leakage ofcorrosive liquid from the battery.In the event of leakage of electrolyteflush with water and seek medical helpif it comes in contact with the eyes etc.1. Set the Main switch to position1.2. Place the product in the charging station.3. Open the hatch and slide the product in asfar as possible to ensure proper contactbetween the product and the chargingstation.36 - Operation 1201 - 001 - 05.06.2019