Honeywell Galaxy 8 User Manual

Also see for Galaxy 128: User guide User guide Programming manual

Honeywell Galaxy 8 User Manual Manual pdf 26 page image

User Guide Galaxy 8/18/60/128/500/504/51220PIN CHANGE (Galaxy 128, 500, 504 and 512)To program a user code as a PIN Change code, select the TemporaryCodes option and press the T key instead of a number of days for atemporary code. Press the ent key to accept the programming and returnto the previous menu level. A code assigned as a PIN Change code isindicated on the user code display by a T between the user numberand the user name, e.g. 001 T USER. If a user is assigned the PINChange feature in the Temporary Code option, the user must assigna new PIN after a predetermined period of time otherwise the PINexpires and is no longer operational. A notification (1 ñ 28 days) thatthe PIN requires to be changed can be assigned using the PIN Warningoption. This prompts the user to assign a new code whenever theexpiring code is entered during the PIN Warning period (except duringsystem unsetting). The new PIN must be four to six digits long andmust be different from any current PIN. The new PIN must be re-entered and if confirmed, returns the user to the banner. If the esc keyis pressed or the new PIN entered is invalid, the user may continue touse the panel as normal. The next PIN entry will prompt the PIN change.Note: If the user has not entered a new PIN by the end of thePIN Warning period, then the PIN is erased on the nextunsetting of the system.kcolBpuorG puorGlacisyhP8-1A Ü 8-18-1B Ü 61-98-1C 42-718-1D 23-52Ü .005yxalaGehtnoelbaliavaspuorGMODIFY GROUPS (Galaxy 18, 60, 128, 500, 504 and 512)This option determines the system groups that the user has access toand operational control over. The MODIFY GROUPS option isonly available when the Group Mode has been enabled by theengineer. The system defaults to groups disabled.Groups allocated to the user are displayed when the MODIFYGROUPS option is selected. All users default to Group 1. Pressing8PIN + ententent0 = OMIT ZONES[ent] to Selectentent8 = CODES[ent] to SelectCODES1 = User Codes001 USERL3 A ________[ent] to Select1 = Modify PIN6[ent] to Select6 = Modify GroupsGroups A 1_______>A 1_______Groups B 1_______>B 1_______Groups B 1_______>B _23_____1+2+3>A