Honeywell Galaxy 8 User Manual

Also see for Galaxy 128: User guide User guide Programming manual

Honeywell Galaxy 8 User Manual Manual pdf 24 page image

User Guide Galaxy 8/18/60/128/500/504/512180 = OMIT ZONES[ent] to Select8PIN + ent8 = CODES[ent] to SelectentCODES1 = User Codesentent001 USERL3 A1_______ð[ent] to Select3 = Modify PIN3001 NAME USER_EFG HIJKLMNØö0 Pent[ent] to Select4 = Time Zone[ent] to Select3 = Modify Nameentent[ent] to Select0 = OFFentUse the A keyto step throughthe four timezone options.>A• QUICK MENUAll user codes default to the quick menu. This menu is made up ofa selection of ten options (0 – 9) from the menu options 11 – 68.The user code level controls access to the quick menu. Any usercan be upgraded from the quick menu to the full menu by assigninga * to the user while the Modify Level option is accessed. Thereforea user with a level *5 would have access to the full menu fromoptions 11 – 39. No code can access both menus.Note: The manager code defaults to the quick menu on theGalaxy 8 and 18, but defaults to the full menu on the Galaxy60, 128, 500, 504 and 512.MODIFY NAMEThis allows a name to be assigned to the user (maximum six characters).Each of the user codes default to the name USER and the managerdefaults to MGR. The manager name cannot be changed. On selectingthe Modify Name option, a section of the alpha-numeric that can beassigned to the user name is displayed on the bottom line of the keypad;the cursor flashes on the letter L. Press * to erase the letters of thedefault or previous name. When the previous name has been erased,use the A> or keys to move the cursor to the first letter of the nameand press the ent key. The selected character appears on the top line,continue this process until the name is completed. The # key togglesbetween upper and lower case characters and the system library. Pressesc to save the name and exit.TIME ZONE (Galaxy 60, 128, 500, 504 and 512)Managers can allocate time zones to user PINs when TIMERS havebeen programmed by the engineer. Time zones are used to disable theuser PIN during the times (ON to OFF) programmed in TIMER Aand B.When 4 = TIME ZONE displays, press the ent key . Using the A> keyselect the time zones option to be allocated to the PIN. The followingtime zones options are available:0=OFF1=TIMER A2=TIMER B3=TIMER A+BThe times assigned to Timer A and Timer B can be viewed usingoption 45 Timer Control. No access will be granted if a code, assignedto 1=Timer A, 2=Timer B or 3= Timer A+B is entered out with theassigned times, an Illegal Code event is recorded in the log and anyoutputs programmed as Illegal Code are activated.