Honeywell 5110XM User Manual

Contents

Honeywell 5110XM User Manual Manual pdf 10 page image

– 6 –REMOTE KEYPAD USER CODESGeneralIf your system has a remote keypad installed, your installer will have programmed a 4-digituser code (known as User Number 2 code) that can be entered at your keypad to silence/resetalarms and activate the fire drill test. This code may also be used to assign up to four otheruser codes (known as User Number 3–6 codes).The User Number 3–6 codes are intended for users who need limited and/or temporarycontrol over system operation. These codes can perform the same functions as the UserNumber 2 code except for assigning user codes and activating the fire drill test.To Assign, Change, or Delete User CodesUser Number 2 can change, but not delete, their own code and can assign, change, or deletecodes for User Numbers 3–6.User Numbers 3–6 cannot assign, change, or delete user codes.1. Enter the User Number 2 code and press the CODE key.2. Enter a single-digit User Number (2–6) for the user whose code is to be assigned,changed, or deleted.3. If assigning or changing a user's code, enter the new 4-digit code for that user.The keypad will beep once, indicating that the new code has been accepted.If deleting a user's code, perform steps 1 and 2 and then stop. After a fewmoments the keypad will beep once, indicating that the existing code has beendeleted.NORMAL STANDBY OPERATIONYour system provides the following indications when in normal operation and there are noalarm, supervisory, or trouble conditions present:• The control's AC POWER LED is lit.• The control's built-in buzzer and keypad warning buzzer and external alarmsounders are off.• The Alpha keypad's LCD display. Fixed Word keypad LCD display.AC