System Administration and StorageViewing System Status InformationMakito X User’s Guide, v2.0, Issue 01 171The Status settings are read-only. For details, see the following section, “Status Set-tings”.2. To reboot the encoder, see “Rebooting the Encoder” on page 172.3. To display a snapshot of system information, see “Taking a System Snapshot” onpage 172.Status SettingsThe following table lists the Status settings and controls. Status information can be usefulfor troubleshooting and may be forwarded to Haivision Technical Support if you arerequesting technical support.Status Setting Description/ValuesCard Status OK (or error message if applicable).Card Type The type of encoder, e.g., Makito2 Dual-SDI Encoder.Part Number The Haivision part number for the encoder, e.g., B-292E-HDSDI2Serial Number The serial number for this encoder appliance or card.Firmware Version The firmware version of the encoder, e.g., v2.0-47Firmware Date The firmware release date.Firmware Options (If applicable) Firmware options installed, e.g., KLV-COT(Metadata Capture KLV & COT). For more information,see “Configuring Metadata Capture” on page 106.Hardware Version The hardware version of the encoder.Hardware Compatibility -001G (basic card assembly).CPLD Version The CPLD version of the encoder.Boot Version The Boot version of the encoder.System Uptime The length of time the encoder has been “up” andrunning (e.g., 1 day 03:42:03).Encoding Chipset Load The combined video encoding processor usage inpercentage% (combining both Hi and Lo streams).Displays a snapshot of system information in a newwindow. See “Taking a System Snapshot” on page 172.Reboots the encoder. See the following section,“Rebooting the Encoder”.
