HP 98568A Installation Instruction

HP 98265A Small Computer Systems Interface (SCSI)• The select code for the SCSI interface card is set by the select code switchesfound on the System Interface Board. The default setting (set at the factory)is 14.Note Both the SCSI and the HP 98625A/B interfaces are presetto select code 14. If you have both SCSI and HP 98625A/Binterfaces, change the select code of the HP 98625A/B Interfaceto an unused value.• The block-mode major number for SCSI interface is 7.• The character-mode major number for the SCSI interface is 47.• The minor number for a SCSI interface at select code 14 is OxOeOnOO, wheren is the number that identifies the address of the disk drive.For instance, suppose you are using an HP 7959S disk drive:Table 5-25.Path File Major Minor InterleaveDevice Name Name Type Number Number * FactorHP 79598 dev/dsk/OsO b 7 OxOeOnOO 1HP 79598 dev/rdsk/OsO c 47 OxOeOnOO 1* n is a number that identifies the address. Replace n with a 0 if the addresswas set to 0, use 2 if the address was set to 2, and so on.5-118 Adding Interface Cards