157MPUs and LPUs Slot arrangementFIP-10FIP-20FIP-110FIP-210FIP-240FIP-300FIP-310FIP-600SAP/OAPSlot 0 through slot 3, slot 6 through slot 9Interface numberingBefore installing a HIM/MIM, you must install a FIP.The interfaces of the router are numbered in the form of interface-type X/Y/Z,Where,• interface-type—Type of the interface such as GE port and serial port.• X—Number of the slot where the FIP/SAP resides.• Y—Sub-slot number—The number of the slot where the HIM/MIM resides on the FIP, If a SAP isinstalled, the sub-slot number is 0.• Z—Sequence number of the interface on the HIM/MIM or on the SAP.NOTE:• Different interface modules on the same FIP have the same slot number X.• Different interfaces on the same HIM/MIM have the same sub-slot number Y.• For each type of interface, the sequence number Z starts from 0 on the interface module.ExamplesExample 1A MIM-2GBE module is installed on the FIP-110 in slot 3.Fixed GigabitEthernet interfaces on the FIP-110• GigabitEthernet 3/0/0• GigabitEthernet 3/0/1NOTE:The sub-slot number Y of fixed GE interfaces on a FIP is 0.GigabitEthernet interfaces on the MIM-2GBE1. If the MIM-2GBE is installed in slot 1 of the FIP-110, the GigabitEthernet interfaces are:{ GigabitEthernet 3/1/0{ GigabitEthernet 3/1/1
